Adjustments An adjustment is specified by a mode, a direction and a delta. For each reference point and corresponding shift vector, the adjustment is computed and applied. The resulting shift vector is again cached in the warping library. This way of implementation allows incremental adjustments. Mode defines the way of the distortion. Following modes are available: Parallelogram Trapezoid Pin balance Pincushion Shift Size Rotation (around bitmap image center point) Direction specifies the direction in which the distortion is applied. Following directions are available: Up Down Left Right Delta specifies the amount of distortion that is applied. Delta is an unsigned integer value in range 0..255 (1 byte). The delta is added to the existing offset of the corresponding reference points. Predefined Adjustments Based on mode and direction, the following transformations are possible: Mode Direction Trapezoid Parallelogram Pincushion Pin balance Up Down Left Right Mode Direction Size Rotation Shift Up Down Left Right Formulas for adjustments The following formulas describe the mathematically necessary adjustments of the reference points. If the requested adjustment exceeds the limit, no calculation shall be done and the previous status will be kept. Trapezoid mode Parallelogram mode Pinbalance mode Pincushion mode Size mode Rotation mode Shift mode NumOfRefPointsX - number of reference points in horizontal direction NumOfRefPointsY - number of reference points in vertical direction x[i][j] - x-coordinate of reference point, a 2-dimensional array of floating point variables y[i][j] - y-coordinate of reference point, a 2-dimensional array of floating point variables