Setup Build To use the Frame Debugger, build the application with these CMake flags enabled: FEATSTD_MONITOR_ENABLED Enables basic Monitor features. MONITOR_FRAME_DEBUGGER_ENABLED Enables basic frame debugger (frame timeline capture, single step mode, no OpenGL specific features). MONITOR_FRAME_DEBUGGER_OPENGL_CAPTURE_ENABLED Enables OpenGL specific Frame Debugger features. COURIER_RENDERING_MONITOR_ENABLED Additional flag required for Courier apps to enable monitor. Also make sure MONITOR_COM_TYPE is set to FEATSTD_COM_TYPE_TCPIP and MONITOR_TCPIP_ADDRESS and MONITOR_TCPIP_PORT are set to appropriate values. Additional CMake flags: The flag MONITOR_SINGLE_STEP_INTERVAL can be used to set the time in milliseconds that is used when incrementing the animation time in single-step mode. Render loop When using an application with a custom render loop (anything else than Player) add these macros to the beginning and end of the loop (defined in Candera/System/Monitor/MonitorPublicIF.h): MONITOR_MARKER_BEGIN_FRAME(); MONITOR_MARKER_END_FRAME(); CGI Analyzer To start the Frame Debugger, configure the connection settings in CGI Analyzer and then connect to the running application: